Playback; Basic Operations - Yamaha RX-V363 - AV Receiver Owner's Manual

Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.

Basic operations

1
Turn on the video monitor connected to this
unit.
Press I SPEAKERS repeatedly to select the
2
front speakers you want to use.
The respective speaker indicators lights up in the
front panel display.
Press N INPUT l / h repeatedly (or press
3
one of the input selector buttons ( 3 )) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
Available input source
DVR V-AUX
INPUT: DVD
Currently selected input source
4
Start playback on the selected component or
select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 37 for details about FM or AM tuning
instructions.

Playback

DTV/CBL DVD MD/CD-R TUNER CD
Rotate H VOLUME (or press I VOLUME
5
+/–) to adjust the volume to the desired
output level.
Press K PROGRAM l / h (or press 4 AMP
6
and then press 0 PROG l / h) repeatedly to
select the desired sound field program.
The name of the selected sound field program appears
in the front panel display.
See page 34 for details about sound field programs.
M o v i e D r a m a t i c
Currently selected surround field program
Notes
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the
input source (see page 30).
• When PCM signals with a sampling frequency higher than 48
kHz are input, this unit is automatically set to the "STRAIGHT"
mode (see page 36).
• To display information about the currently selected input source
in the front panel display, see page 32 for details.
■ Guide to contents
When you want to...
Adjust the tonal quality of the front speakers
Edit parameters of sound field programs
Enjoy the sources which have wide dynamic range at
night
Use headphones
Select a decoder to play back sources with
Set this unit to the standby mode automatically
PLAYBACK
See
page
31
35
31
30
35
33
29
En