Left Side Panel; Right Side Panel - Fishman AURA SPECTRUM DI User Manual

Left Side Panel

Output
Use a standard ¼-inch instrument cable to connect the output to your
amplifi er, mixer or effects devices. You can also connect this output to
an unbalanced input on a recording system.
Connecting a guitar cable here will also lift the ground on the XLR D.I.
output, preventing unwanted ground loops.
FX Loop
This tip/ring/sleeve connection allows you to insert external devices, such
as the Fishman AFX Acoustic Effects, between Aura Spectrum's blended
signal and the main outputs. Any pedals you connect here will appear at
the 1/4" and XLR D.I. outputs. The overall output level will still be affected
by Aura Spectrum's volume control.
9VDC
Power may be supplied by either a 9V battery ( battery compartment
underneath the pedal ) or the Fishman 910-R ( for 110V ) .
14

Right Side Panel

T rim
Raise or lower the trim to optimize the input level for your pickup. Play
hard and adjust trim so clip/batt fl ashes occasionally. Some pickup
systems may not cause the light to fl ash at all and other onboard preamps
may require you to turn their output down to achieve an optimum level.
Phase
Use the phase switch to improve bass response at low volume and sup-
press feedback at high volume. Move the phase switch and leave it in
the position most pleasing to your ear.
USB
After installing Aura Image Gallery software, connect your computer here.
Input
Plug in your guitar here with a standard ¼-inch instrument cable. If you
have a passive undersaddle pickup (no battery onboard), always plug into
the Aura Imaging Pedal fi rst, even if you use a pedal tuner.
Insert a plug into the input jack, and the Aura Imaging Pedal powers up.
To conserve the battery, remove the plug from the input when not in use.
15