Table of Contents
Advertisement
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
2-6-2 Headers
(1)
IEE1394A Port Header (9-pin) : 1394A/1394B (For P4X400DAZ only)
(2)
Line-Out/MIC Header for Front Panel (9-pin): AUDIO
This header connect to Front Panel Line-out, MIC connector with cable.
Without install the cable, this header default setting is 5-6 short, 9-10 short. When you
install the cable you have take off these jumpers.
Pin 1
Secondary IDE Connector
Note: Orient the read marking on the
1394 ribbon cable to pin 1
1394A
1394B
2
10
2
9
Pin 1
Pin 1
IEE1394A Port Header
15
10
9
Hide quick links:
Advertisement
Table of Contents
