Table of Contents
Advertisement
Please refer to section 3-7-1
OnChip Device Function
Please refer to section 3-7-2
Onboard Super IO Function
Please refer to section 3-7-3
Init Display First
This item allows you to decide to activate whether PCI Slot or AGP VGA first. The settings
are: PCI Slot, AGP Slot.
3-7-1 OnChip IDE Function
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
OnChip IDE Channel0
OnChip IDE Channel1
Primary Master
Primary Slave
Secondary Master PIO
Secondary Slave
Primary Master
Primary Slave
Secondary Master UDMA
Secondary Slave
IDE 32-bit Transfer Mode
IDE Prefetch Mode
IDE HDD Block Mode
Delay For HDD (Secs)
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
OnChip IDE Channal0/Channel1
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select Enabled to activate each channel separately. The settings are: Enabled and
Disabled.
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the
best mode for each device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode
4.
Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA/33 and
Ultra DMA/66, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
OnChip IDE Function
Enabled
Enabled
PIO
Auto
PIO
Auto
Auto
PIO
Auto
UDMA
Auto
UDMA
Auto
Auto
UDMA
Auto
Enabled
Enabled
Enabled
0
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
27
Item Help
F1:General Help
Advertisement
Table of Contents
