Chapter 2 Hardware Installation; Hardware Installation Steps; Checking Motherboard's Jumper Setting - JETWAY P400MTR2A User Manual

Hardware installation

2-1 Hardware installation Steps

Before using your computer, you had better complete the following steps:
1. Check motherboard jumper setting
2. Install CPU and Fan
3. Install System Memory (DIMM)
4. Install Expansion cards
5. Connect IDE and Floppy cables, Front Panel /Back Panel cable
6. Connect ATX Power cable
7. Power-On and Load Standard Default
8. Reboot
9. Install Operating System
10. Install Driver and Utility

2-2 Checking Motherboard's Jumper Setting

(1) CPU Front Side Bus Frequency Setting (2x3-pin) : JP3,JP4
CPU Clock
AUTO
100MHz
133MHz
200MHz
(2) CMOS RAM Clear (3-pin) : JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM short 1-2
pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below:
1. Turn off the system and unplug the AC power
2. Remove ATX power cable from ATX power connector
3. Locate JBAT and short pins 2-3 for a few seconds
4. Return JBAT to its normal setting by shorting pins 1-2
5. Connect ATX power cable back to ATX power connector
Chapter 2
JP3
1-2 closed 1-2 closed
2-3 closed 2-3 closed
OFF 2-3 closed
2-3 closed
1 3
JP3
JP4
AUTO
(Default)
CPU Front Side Bus Frequency Setting
7
JP4
(Default)
OFF
1 3 1
JP3
JP3
JP4 JP4
100MHz 133MHz
3 1 3
JP3
JP4
200MHz