ResMed AirFit F30i Disinfection Manual

Disinfection guide
This guide provides the reprocessing instructions for the Sleep Lab Mask (SLM) variants of the AirFit
reuse in a sleep lab, clinic or hospital. The Sleep Lab Mask variant is identified by the "SLM" acronym on the packaging label and a Unique Device Identifier labeling on the mask. If you use the
mask as a single user in the home, refer to the User Guide for cleaning instructions. The processor is responsible for ensuring that reprocessing is completed in accordance with ResMed's validated
procedures. Potable water with hardness ≤150 mg/L is recommended for all cleaning, rinsing and disinfection steps.
AirFit F30i, AirFit X30i
Mask system
AirFit AirFit
F30i X30i Mask component
• – AirFit F30i cushion
• • Frame / frame magnets
• • Elbow body / elbow clip / elbow ring
• • Headgear and magnetic clips
– • AirFit X30i oral cushion
– • Multi-hole vent
– • QuietAir vent
™
– • AirFit X30i pillows / pillows connector
Mask and components may not be available in all regions. For full details regarding the correct use of this mask, please refer to the User Guide. For a list of available replacement parts, check the Product Guide on ResMed.com.
A Elbow body 5 Anti-Asphyxia valve (inside the left and right
of frame connector)
B Frame
C 6
Headgear Frame magnet
1 7
Vent holes (elbow) Magnetic clip
2 Elbow clip 8 Lower headgear strap
3 Elbow ring 9 Upper headgear strap
4 Frame connector
™
Cleaning
Alconox (mild alkaline, anionic detergent)
™
Thermal high level disinfection
167°F (75°C) for 30 minutes OR
194-199°F (90-93°C) for 1 to 10 minutes
–
–
Full face mask
D
AirFit F30i cushion
10 Vent holes (cushion)
F30i, AirFit F30i Non Magnetic and AirFit X30i masks only, which are intended for multi-patient
Validated number of
cycles
30
Not intended for multi-patient
re-use
Additional disassembly
a
d
E
AirFit X30i oral cushion
F
AirFit X30i pillows
11 QuietAir vent
12 Multi-hole vent
13 Pillows connector
Full face mask
Clinical use only
b c
e
English 1