Panasonic EP30007 - Real Pro ULTRATM Operating Instructions Manual page 15

3
Attaching the control panel stand to the right or left side panel of the unit
(Diagram shows attachment to right armrest.)
1. Insert the attachment screw into the lower hole first
and then tighten lightly by hand.
2. Securing the stand with the attachment screws.
Tighten the two screws for the remaining two holes
lightly by hand and then tighten firmly with the allen key.
Control panel stand
1 Insert the attachment
screw in either hole and
then tighten.
Attachment screw
Use this screw
Attachment Screw (M6 × 16)
× 3
4
Attaching the control panel stand covers
(On both the right and left sides)
The method for attaching the covers is the same for both sides.
The diagram shows the side where the control panel stand is
attached.
1. Insert the top tabs on the cover into the bottom
notches on the armrest.
Notches
2
Allen key
Top tabs
The position of the control panel when seated can be
selected by choosing the appropriate hole for the screw.
Near
To attach the control panel stand using the attachment
screws, tighten the screws level with the holes as
shown in the figure below.
If the screws are tightened at an angle, the hole may
become deformed and the screws may become stuck in
the middle.
Control panel stand
Hole
Allen key
Tighten the screws
level with the holes.
Cover for Side WITH
Control Panel Stand
2. Insert the bottom tabs into the notches on the
armrest.
Control panel
stand cover
Approx.
20˚
Far
Attachment screw
Hole
Allen key
Do not tighten the
screw at an angle
with the hole.
Cover for Side WITHOUT
Control Panel Stand
Bottom tabs
Push the cover until
Notches you hear it click.
Control panel
stand
Attachment
screw
12