Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual page 73

RECORDING SETUP screen (continued)
Item
UB MODE
UB PRESET
1394 IN PRESET
This is used to set what is to be recorded as the user's bit.
USER:
The user information is recorded.
TIME:
The time of the recording is recorded.
DATE:
The date/time of the recording are recorded.
TCG:
The value generated by the time code generator is recorded.
FRM. RATE:
The information of the frame rate after frame conversion is recorded.
a b c
a: Information on the verification of the user's bit value
b: Frame sequence number
•"F" is displayed in the 60i/30P mode.
c: Frame rate information
• Frame rate (60, 30 or 24)
• I/P identification information
• Conversion information
• Frame rate factor
d: Recording control information
• Update frame information
• REC START/STOP information
Note
When playing back native recorded clips
To set the 1394 output user's bit as the frame rate information, select FRM. RATE for
this setting, and play back the clips. If this is the case, the user's bit displayed on the
screen will also be changed to the frame rate information.
This is used to set the user's bit. However, USER must be selected as the UB MODE
item setting.
When [RESET/TC SET] is pressed, the value generated by the internal time code
generator is synchronized with the 1394 input time code.
ON:
The 1394 input synchronization setting mode is established.
OFF:
The 1394 input synchronization setting mode is released.
Description of settings
d
The underlined settings are the factory mode settings.
73