How To Install The Stand - Sanyo HEC-DR6700K - Zero Gravity Massage Chair Instruction Manual

HOW TO INSTALL THE STAND

Installation on the right-hand side of the chair
Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver (Åñ screwdrivers are not included)
1
Remove the cover of the right-hand
side of the arm rest.
Insert the flathead screwdriver into the
holes under the cover and pull toward
you. (4 places)
Cover A
ÖA Pull toward you.
Ö@ Insert
2
Secure the stand on the right-hand
side of the arm rest, using the
installation screws (3 screws).
Installation
screws
3
Place the cover on the right-hand
side of the arm rest.
9
4
Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Put the remote control on the remote
control stand in a tilted position as the
arrow shows, and then push it in the
Ö@
direction of arrow .
ÖA
ÖA
Ö@
Remote control
Remote control
stand
Sensor controller
Sensor controller stand
5
Put the cords of the remote control
and the sensor controller in the
hooks of the sensor controller stand.
The post holder in the lower part of the
sensor controller stand has hooks on both
sides. Place the sensor controller cord with
the stopper in the hook closer to the arm
rest. Place the remote control cord in the
opposite hook.
Remote control
Sensor controller stand
Post
Sensor
controller
Stopper
Hook
Arm rest
Post holder
Installation on the left-hand side of the chair
Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver (Åñ screwdrivers are not included)
1
Remove the covers on the outer
sides of the arm rests.
Insert the flathead screwdriver into the
holes under the cover and pull toward
you. (4 places)
Cover B
2
Secure the stand on the left-hand
side of the arm rest, using the
installation screws (3 screws).
Installation
screws
3
Place the covers on the outer sides
of the arm rests.
Install the cover A on the left-hand side,
and cover B on the right-hand side.
Cover A
4
Uninstall the cord hook from the
right-hand side of the arm rest,
and install it on the left-hand side.
ÖA Install
Ö@ Uninstall
5
Put the cords of the remote control
and sensor controller in the cord
hook on the back of the body.
Remote control cord,
Sensor controller cord
Cord hook
Ö@ Uninstall
ÖB Install
ÖA Thread the cord
6
Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Put the remote control on the remote
control stand in a tilted position as the
arrow Ö@ shows, and then push it in the
direction of arrow .
ÖA
ÖA
Ö@
Remote control
Remote control
stand
Sensor controller
Sensor controller stand
7
Put the cords of the remote control
and the sensor controller in the
hooks of the sensor controller stand.
The post holder in the
Remote control
lower part of the sensor
controller stand has
hooks on both sides.
Place the sensor
controller cord with
the stopper in the hook
closer to the arm rest.
Place the remote control
cord in the opposite
hook.
Sensor controller
Sensor controller stand
10