How To Install The Stand - Sanyo HEC-DR8700 Instruction Manual

HOW TO INSTALL THE STAND

Tools needed: Phillips (crosshead) screwdriver
Remove the cover attached to the
1
right face of the right arm rest.
Gently pull the lower portion
of the cover toward you.
Secure the stand on the right-hand
2
side of the arm rest, using the
installation screws (3 screws).
Reattach the cover to the right
3
side of the arm rest.
Press the lower
portion of the
cover until you
hear a click.
4
Cover
5
Hand screw
Installation
screws
6
Screwdriver is not included.
Installation screws are included in the accessory
box. (See page 6)
Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Place the remote control in the remote control stand
as indicated by arrows ① and then push it in the
direction of arrow ②.
②
Remote ①
control
Sensor
controller
Place the sensor cable into the hook
on the left side of the sensor stand.
Stopper
Attach so that the
stopper is set into
the top of the hook.
Place the remote control cable into
the hook on the right side of the
sensor stand.
Remote control cord
Remote control
stand
If the remote control
stand moves too
loosely, tighten the
hand screw.
Sensor controller
stand
Hook
Sensor controller
cord
Hook
10