Sanyo HEC-DR6700K - Zero Gravity Massage Chair Instruction Manual page 9

ADJUSTMENT OF CHAIR
6
Adjust the angle of the foot rest.
Foot rest can be adjusted independently.
Keep the FOOT REST button pressed until
the desired angle is achieved.
When massaging the soles or calves, adjust
the angle so that the massaging part of the
foot rest touches the soles or calves.
Raise the foot rest by
continuously pressing the
UP ( ) button.
Lower the foot rest by
continuously pressing the
DOWN ( ) button.
(Remote control)
7
Position is returned automatically
to the home position when
the HOME POSITION button
is pressed.
The foot rest is raised first, and
then goes down completely.
15
WARNING
When the foot rest is suddenly released
after being raised by hand, it will return
forcibly to the previous position.
For safety, be sure to lower the foot rest
slowly using your hand.
Foot rest
Adjustment range
Approx. 90Åã
Foot rest
Press
MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSES)
1
Press the OPERATION ON/OFF button.
When the button is pressed, the lamp of the remote control
illuminates and the sole warmer will turn on.
When the foot rest is fully lowered, the foot rest will rise a little.
When the massaging rollers are not located in the upper section,
the massaging rollers will move to the upper section and stop.
(During the movement, the characters of "ORIGIN" on the remote
control flicker.)
2
Turn the sole warmer on or off.
Sole warmer will be turned on or off each time the SOLE WARMER button is pressed.
(The button is illuminated while the sole warmer is on.)
If you feel that the sole warmer is too hot, turn it off by pressing the SOLE WARMER button.
Åñ
When the room temperature is low such as in winter, it takes some time to warm up or you
may barely feel heat.
3
Adjust the positions of the back rest and the foot rest.
4
Press the desired Whole Body Sensor Automatic Course button.
STIFFNESS
Firm shiatsu
massage
Back rest
RECOVERY
Tapping massage
to ease muscle
fatigue
Refer to the page 27 and 28 regarding the massaging contents of Whole Body Sensor Automatic Courses.
Change of course during massaging, or change to the Automatic Course or the Manual Course, is possible.
5
Set the sensor controller on the arm rest
and place your fingers on the sensor.
Sensor lamp
Sensor
NOTE
Be sure to place your fingers on the sensor. The degree of stiffness cannot be measured if your fingers are
not placed on the sensor. (The sensor lamp will flicker and the characters of "Grip the sensor" on the
remote control will be illuminated.) In such a case, massages will be carried out according to the standard
operation of the selected course.
When the user's skin is dry, the degree of stiffness may not be measured
correctly. In such a case, slightly moisten the fingers using hand cream and place the fingers on the sensor
again.
RELAX
Kneading massage
to relax the whole
body
FINE
Massage to
promote blood
circulation
Arm rest
Sensor controller
Press
(See page 13-15)
16