Replacing The Remote Control Batteries; Troubleshooting - Bose LS28IIIBLK Operating Manual

Replacing the remote control batteries

Figure 17
Installing the remote
control batteries

Troubleshooting

Problem
System doesn't do any-
thing
No sound
Replace the batteries when the remote control stops operating or its range seems reduced.
Alkaline batteries are recommended.
1. Slide open the battery compartment on the back of the remote (Figure 17).
2. Insert four AAA or IEC-LR3 1.5V batteries, or the equivalent, as shown. Match the + and –
symbols on the batteries with the + and – markings inside the compartment.
3. Slide the battery compartment cover back into place.
AAA batteries (4)
compartment
What to do
• Make sure the power connector is inserted securely into the media center, the power
cord is inserted securely into the Acoustimass
cord are plugged fully into operating AC wall outlets.
• Be sure to select a source (CD/DVD, AM/FM, etc.).
• Unplug the media center power supply for 60 seconds, then reconnect it. This allows the
unit to reset itself after a power surge or power interruption.
• Increase the volume.
• Check to see if MUTE is lit on the display. If it is, press the Mute button on the remote
control to unmute the sound.
• Make sure the audio input cable is firmly seated in the media center SPEAKER ZONE 1
jack and the multi-pin connector on the other end is firmly seated in the Acoustimass
module AUDIO INPUT jack.
• Check speaker connections.
• Turn the media center off for 60 seconds, then on again, to restore communication
between the media center and the speakers.
• Check the connections for any external components. Make sure to select the correct
source for the desired input.
• Be sure the disc is placed correctly, label-side up, in the CD tray.
• Connect the FM and AM antennas.
• Make sure that the power switch on the Acoustimass module is set to ON (I).
AM259776_02_V.pdf • April 23, 2002
+
+
+
+
Battery
compartment
Battery
cover
®
Reference
module, and the power pack and power
39