Rhn Satellite Server::execution Time; Rhn Satellite Server::interface Traffic; Rhn Satellite Server::latency - Red Hat NETWORK SATELLITE 5.1.0 Reference Manual

Table C.63. RHN Satellite Server::Disk Space settings

10.2. RHN Satellite Server::Execution Time

The RHN Satellite Server::Execution Time probe monitors the execution time for probes run
from a Satellite and collects the following metric:
• Probe Execution Time Average — The seconds required to fully execute a probe.
Field
Critical Maximum Probe Execution Time Average
Warning Maximum Probe Execution Time Average
Table C.64. RHN Satellite Server::Execution Time settings

10.3. RHN Satellite Server::Interface Traffic

The RHN Satellite Server::Interface Traffic probe monitors the interface traffic on a Satellite and
collects the following metrics:
• Input Rate — The amount of traffic in bytes per second the device receives.
• Output Rate — The amount of traffic in bytes per second the device sends.
Field
Interface*
Timeout (seconds)*
Critical Maximum Input Rate
Critical Maximum Output Rate
Table C.65. RHN Satellite Server::Interface Traffic settings

10.4. RHN Satellite Server::Latency

The RHN Satellite Server::Latency probe monitors the latency of probes on a Satellite and
collects the following metric:
• Probe Latency Average — The lag in seconds between the time a probe becomes ready to
run and the time it is actually run. Under normal conditions, this is generally less than a
RHN Satellite Server::Execution Time
Value
Value
eth0
30
267