Probe Suites - Red Hat NETWORK SATELLITE 5.1.0 Reference Manual

13. R ecurring Frequency: How often the filter activates.
Notification filters cannot be deleted. However, a filter may be canceled by setting the end date
to some time in the past. (Note that the end date must be equal to or later than the start date, or
the change fails.) Another method is to select a set of filters from the Active page and click the
Expire Notification Filters button in the lower right. These filters are then canceled and
appears in the Expired Filters tab.
10.2.1.2. Notification # Notification Filters # Expired Filters
This tab lists all notification filters whose end date has passed. Expired filters are stored
indefinitely; this allows an organization to recycle useful filters as needed and provides a
historical record for troubleshooting.

10.3. Probe Suites

Probe Suites allow you to configure and apply one or more probes to a system or systems.
Probe Suites may be configured once and then applied to any number of systems in a batch.
This results in time savings and consistency for Monitoring customers.
To create and apply a Probe Suite, first create an empty Probe Suite, then configure member
probes, and finally apply the Suite to selected systems.
1. From the Monitoring # Probe Suites page, select the create probe suite link. Enter an easily
distinguishable name for the Probe Suite. You may also choose to add a brief description of
the Suite. Click the Create Probe Suite button to continue.
2. Add and configure the probes that comprise the Suite. Click the create new probe link in the
upper right.
3. As described in Section 4.2.9.5.2, "System Details # Monitoring —
and click the Create Probe button in the lower right. Repeat this process until all desired
probes have been added.
Note
Sendmail must be configured correctly on your RHN Satellite Server and each
client system to which the Probe Suite is applied must have the
installed and running. Refer to the RHN Satellite Server 5.1.0 Installation Guide
for additional information.
4. Add the systems to which the Probe Suite applies. Click the add systems to probe suite
link in the upper right of the screen to continue.
Probe Suites
", configure the probe
daemon
rhnmd
151