Netscape MANAGEMENT SYSTEM 6.2 - ADMINISTRATOR Administrator's Manual page 334

Setting Up a Trusted Manager
You are returned to the Users tab.
Next, you configure the connector settings of the Registration Manager or
Certificate Manager. This enables the Registration Manager or Certificate
Manager to utilize the agent port to communicate with the subsystem.
Note that during the installation of a Certificate Manager, you were prompted
to specify the host name and port number of the Data Recovery Manager to
which the Certificate Manager will be connected. If you specified this
information, the connection has already been made, you do not need to
perform the rest of this procedure.
Log in to the CMS console for the Registration Manager or Certificate Manager
11.
(see "Logging Into the CMS Console" on page 245).
In the navigation tree, select Registration Manager or Certificate Manager.
12.
The General Settings tab appears in the right pane.
Select the Connectors tab.
13.
In the "List of connectors" select the connector:
14.
The Edit Connector dialog opens.
Select Enable to enable the connector configuration, and enter the appropriate
15.
information:
Host. Type the fully qualified host name of the subsystem that trusts this
Registration Manager or Certificate Manager.
Port. Type the number of the TCP/IP port number of the agent port for the
subsystem that trusts this Registration Manager or Certificate Manager.
Timeout. Specify the connection timeout. The default is 30 seconds.
Click OK.
16.
You are returned to the Connectors tab.
To save your changes, click Save.
17.
334 Netscape Certificate Management System Administrator's Guide • June 2003
If you are connecting the Registration Manager or Certificate Manager to a
Certificate Manager, select Certificate Manager Connector and click Edit.
If you are connecting the Registration Manager or Certificate Manager to a
Data Recovery Manager, select Data Recovery Manager Connector and
click Edit.