Red Hat LINUX 7.1 - ISERIES Manual page 54

54
In order to reboot properly you must save the kernel image and kernel com-
mand line arguments into your IPL source. Log in to Linux and follow the
appropriate instructions below.
If you have installed onto virtual disks and have no SCSI disks, use these two
commands:
If you have both virtual and SCSI disks, and want to IPL from the PReP Boot
partition on the first virtual disk, use these two commands:
If you have SCSI disks (with or without virtual disks) and want to IPL from
the A or B side, use these two commands:
substituting b for the a argument in each command to install the kernel and
command line on the B side.
It may take a minute or longer for the /sbin/installkernel command
to complete.
Now you may shutdown Linux and vary off the LPAR. Before you vary on again, you must set the
IPL source to for the LPAR to
Remember that the only place you can log in as root is at the console or other devices as listed in
/etc/securetty. If you want to log in as root from remote systems, use ssh.
/sbin/installkernel prep
/sbin/installcmdline prep
/sbin/installkernel prep
/sbin/installcmdline prep
/sbin/installkernel a
/sbin/installcmdline a
*NWSSTG
Chapter 3:Installing Red Hat Linux
CAUTION
Note:
, , or .
A B