Network Configuration - Red Hat LINUX 7.1 - ISERIES Manual

34 Chapter 3:Installing Red Hat Linux
Figure 3–10 Choosing Partitions to Format
Note
It is never necessary to check for bad blocks on a virtual disk.
If you wish to check for bad blocks while formatting each filesystem, please make sure to select the
checkbox. Checking for bad blocks can help prevent data
Check for bad blocks while formatting
loss by locating the bad blocks on a drive and making a list of them to prevent using them in the future.

3.11 Network Configuration

If you do not have a physical LAN card or virtual LAN, you will not see this screen. Please skip ahead
to the next section, Section 3.16, Time Zone Configuration.
If you have a physical LAN card or virtual LAN, and you have not already configured your networking,
you now have the opportunity (as shown in Figure 3–11, Network Configuration).
If there is more than one LAN interface allocated to the LPAR, this dialog configures the primary
interface. This will enable tools such as setup to configure the others later. Other network interfaces
can be configured after installation, using the setup command.