Red Hat ENTERPRISE LINUX 4 - USING BINUTILS Using Instructions page 52

46
-o
filename
-output
filename
The name of the output file. If this option is not used, then
argument, after any used for the input file name, as the output file name. If there is no non-option
argument, then
standard output. Note, for compatability with
not recommended.
-J
format
-input-format
format
The input format to read.
will guess, as described above.
windres
-O
format
-output-format
format
The output format to generate.
will guess, as described above.
windres
-F
target
-target
target
Specify the BFD format to use for a COFF file as input or output. This is a BFD target name;
you can use the
default format, which is the first one listed by the
-preprocessor
program
When
windres
used to specify the preprocessor to use, including any leading arguments. The default preproces-
sor argument is
-I
directory
-include-dir
directory
Specify an include directory to use when reading an
processor as an
in the file. If the argument passed to this command matches any of the supported
rc
(as descrived in the
option. New programs should not use this behaviour. If a directory happens to match a
simple prefix it with
-D
target
-define [=
sym val
Specify a option to pass to the preprocessor when reading an
-D
-U
target
-undefine
sym
Specify a option to pass to the preprocessor when reading an
-U
-r
Ignored for compatibility with rc.
-v
Enable verbose mode. This tells you what the preprocessor is if you didn't specify one.
will write to standard output.
windres
may be
format
format
option to see a list of supported targets. Normally
-help
reads an file, it runs it through the C preprocessor first. This option may be
rc
gcc -E -xc-header -DRC_INVOKED
option.
-I windres
option), it will issue a deprecation warning, and behave just like the
-J
to disable the backward compatibility.
./
]
windres
the option
rc
, , or
res rc coff
may be , , or
res rc
option. Section 16.1 Target Selection.
-help
.
file.
rc
will also search this directory when looking for files named
Chapter 13. windres
will use the first non-option
windres
can not write a COFF file to
is also accepted, but its use is
-fo
. If no input format is specified,
. If no output format is specified,
coff
windres
will pass this to the pre-
windres
file.
rc
file.
rc
will use the
formats
-J
,
format