Red Hat ENTERPRISE LINUX 3 - INSTALLATION GUIDE FOR IBM ESERVER ISERIES AND IBM ESERVER PSERIES Installation Manual page 51

Chapter 2. Installing Red Hat Enterprise Linux
2. Copy the first installation disc onto a file system of another Linux system or other Linux system.
3. Make this copy of the installation disc available through NFS or FTP.
4. Vary off or power down the system you need to rescue. Set its IPL parameters as instructed for
booting the Installation discs in rescue mode, except that the IPL source should point to the copy
of on your IFS (from step 1, above).
boot.img
5. Make sure the installation disc is not in your CD-ROM drive.
6. IPL the Linux system.
7. Follow the prompts as decribed in Section 2.27 iSeries and pSeries — Rescue Mode. An addi-
tonal prompt for the installation source appears. Select NFS or FTP (as appropriate) and com-
plete the following network configuration screen.
8. When the Linux system has booted into rescue mode, the CD-ROM drive is available for use
and you can mount the driver media to access the SCSI utilities.
43