Table of Contents
Advertisement
40
Figure 2-27. X Customization
Tip
To change your X configuration after you have completed the installation, use the X Configuration
Tool.
Type the
redhat-config-xfree86
If you are not root, it prompts you for the root password to continue.
2.26. Installation Complete
Congratulations! Your Red Hat Enterprise Linux 3 installation is now complete!
The installation program prompts you to prepare your system for reboot.
iSeries — Completing the Installation
When the installation program completes, it prompts you to press the [Enter] key. The LPAR
then reboots with the installed Red Hat Enterprise Linux OS.
The installation program has completed the following tasks:
Installed a kernel to the B slot and kernel parameters ro root=LABEL=/
•
Installed a kernel to the PPC PReP boot partition, if one exists
•
The A slot has been left alone for the users discretion
•
Tip
iSeries users may also find the following information about kernel slots useful:
http://www-1.ibm.com/servers/eserver/iseries/linux/tech_faq.html
Chapter 2. Installing Red Hat Enterprise Linux
command in a shell prompt to launch the X Configuration Tool.
Advertisement
Table of Contents
Need help?
Do you have a question about the ENTERPRISE LINUX 3 - INSTALLATION GUIDE FOR IBM ESERVER ISERIES AND IBM ESERVER PSERIES and is the answer not in the manual?
Questions and answers