Time Zone Configuration - Red Hat ENTERPRISE LINUX 3 - INSTALLATION GUIDE FOR IBM ESERVER ISERIES AND IBM ESERVER PSERIES Installation Manual

32
Caution
If you select only one language, you can only use that specified language after the installation is
complete.
Figure 2-19. Language Support Selection
To use more than one language on your system, choose specific languages to be installed or select all
languages to have all available languages installed on your Red Hat Enterprise Linux system.
Use the Reset button to cancel your selections. Resetting reverts to the default; only the language you
selected for use during the installation is installed.
Tip
To change the language configuration after you have completed the installation, use the Language
Configuration Tool.
Type the
redhat-config-language
ration Tool. If you are not root, it prompts you for the root password to continue.
2.19. Time Zone Configuration
You can set your time zone by selecting your computer's physical location or by specifying your time
zone's offset from Universal Time, Coordinated (UTC).
Notice the two tabs at the top of the screen (refer to Figure 2-20). The first tab allows you to configure
your time zone by your location.
On the interactive map, you can also click on a specific city, which is marked by a yellow dot; a red X
appears indicating your selection. You can also scroll through a list and choose a time zone.
Chapter 2. Installing Red Hat Enterprise Linux
command in a shell prompt to launch the Language Configu-