Table of Contents
Advertisement
72
Figure 4–23 Installing Packages
4.25 Installation Complete
Congratulations! Your Red Hat Linux 7.1 installation is now complete!
The installation program will prompt you to prepare your system for reboot. Do not forget to remove
any diskette in the diskette drive or CD in the CD-ROM drive.
After rebooting, you must set the open firmware boot device to the disk containing your Red Hat
Linux PReP and / partitions. To accomplish this, wait until the LED indicator says E1F1, then press
to enter the
[F1]
containing your Red Hat System and type 1. Set the other devices as you wish, then click on
then
. Click on
Exit
After your computer's normal power-up sequence has completed, you should see YABOOT's GUI
prompt, at which you can do any of the following things:
•
Press
[Enter]
•
Select a boot label, followed by
sponding to the boot label. (Press
System Management Services
from the main menu to boot your new system.
Exit
— causes YABOOT's default boot entry to be booted.
[Enter]
GUI.. Click on
— causes YABOOT to boot the operating system corre-
at the YABOOT: for a list of valid boot labels.)
[?]
Chapter 4:Installing Red Hat Linux
, then select the disk
Boot Sequence
Save
,
Advertisement
Table of Contents
