AMX Modero NXA-WAP200G Instruction Manual page 50

Wireless Device Communication Setup
11. Press the Security tab, from the Configuration Utility, to open the Security and Encryption
Settings page (FIG. 31).
FIG. 37 Bridge Mode Security and Encryption page
For the purposes of these procedures, the WEP Encryption procedures and setup
parameters will be used. Refer to the Security and Encryption Settings Page (Bridge
Mode) section on page 67 for more information on the various fields within this page.
12. Place a checkmark within the Enable WEP checkbox field to enable WEP encryption.
A hex digit is either a number from 0 to 9 or a letter from A to F. If you leave a key box
blank (empty), this equates to a key of all zeros.
13. Click on the right drop-down arrow and choose an encryption key size and length from the
WEP Key Length field listing. The available choices are: 64 bit (10 hex digits), 128 bit (26 hex
digits), 64 bit (5 ASCII chars), and 128 bit (13 ASCII chars).
44
To implement this type of encryption, you must enter the same KEY from the WAP200G
into any communicating wireless devices.
For 64-bit encryption keys, you must enter 10 hex digits or 5 characters into the following
WEP Key field.
For 128-bit encryption keys, you must enter 26 hex digits or 13 characters into the
following WEP Key field.
WEP Configuration
WPA Configuration
NXA-WAP200G Wireless Access Point