AMX Modero NXA-WAP200G Instruction Manual page 49

FIG. 36 Bridge Mode Basic Wireless Configuration page
3. Enter the desired SSID into the Wireless Network Name (SSID) field. The alpha-numeric string
is AMX by default but can be changed to any 32-character entry. This string must be
duplicated within the Network Name (SSID) field on the Modero's Secondary/Wireless
Connection page.
4. Enter the MAC Address (BSSID) of the target Wireless Access Point into the Desired MAC
field. This value is manually entered and must match the value of the target WAP. This value
can be copied from the listing of available WAPs's BSSIDs that appear on the bottom of the
Status page.
5. Press the right drop-down arrow and choose a radio channel from the Channel field listing.
This selection is used when the WAP200G is both working and using an ad-hoc wireless
network type.
6. Leave the Transmission rate at its default setting of Best (automatic) unless a specific
transmission speed is necessary.
7. Press the right drop-down arrow and choose a wireless network selection from the Wireless
Mode field listing. This selection determines whether the Bridge will connect to an 802.11g
only network, 802.11b only network, or a combination therein.
8. Click the Save button to incorporate this new information. This action acts to reboot the unit
and incorporate the new information
9. Click the Reboot button from the new Temporarily Saved page that appears.
10. Click OK to reconfirm you want to reboot the WAP200G. Wait a few seconds for the Status
page to reappear within the web browser.
NXA-WAP200G Wireless Access Point
Whatever alpha-numeric string is used for the WAP200G's SSID field must be duplicated
within the corresponding Network Name (SSID) field of any communicating Modero
panel.
Wireless Device Communication Setup
SSID Broadcast
SSID Broadcast name
MAC Address of target WAP
Frequency & Channel
(no effect in ad-hoc mode)
Bridge connection mode
43