Table of Contents
Advertisement
Basic Operations
Capturing An IR File
With the use of an IRIS, IREdit can capture IRs into hand control functions specified by you.
1. Select Tools > Comm Settings > Capture Tab to set the port location of the IRIS. Select OK.
2. In the IR Document window select the channel into which you want to capture.
3. Select Tools > Capture. This will launch the IR Capture Wizard.
4. You will need to enter the function name and select Next.
5. Hold the hand control approximately three inches from the IR capture window. Press and hold
down the first key on the hand control to capture the first function. The SIGNAL LED will start
blinking. Hold just until the READY LED goes off. When the READY LED comes back on,
repeat this step to confirm the IR signal.
6. Push the Send button on the IRIS.
7. The IR Capture Wizard will confirm the information sent to the slot.
8. Click Finish.
IRIS Infrared/Serial Data Capture Unit
The IRIS Infrared Capture Unit is a stand-alone, self-contained unit captures infrared (IR) or
wired-IR function signals from an IR hand control.
For operating instructions on the IRIS, refer to the IRIS Infrared Capture Unit Instruction Manual.
Capture Communication Settings
The connected IRIS must be identified to IREdit.
1. Select Tools > Comm Settings > Capture tab.
2. Click the down arrow to open a menu where you can choose between any number of COM
ports.
3. Click OK.
30
IREdit
Advertisement
Table of Contents
