Installation Of Alarm Led - Whistler CRUISADER Installation Instructions Manual

Cruisader Installation.qxd
Installation of Laser Module Antenna
If there is no fairing suitable to allow the proper orientation of
the laser module, the module can be tie wrapped to the
frame or use the dog bone bracket for a more secure mount.
R R e e a a r r m m o o u u n n t t i i n n g g
The most common place for mounting the laser module is at
the license plate using the dog bone bracket attached to the
plate. Peel the red backing off of the tape and place onto the
dog bone bracket. Make sure that the laser module is orien-
tated correctly as stated in front mounting section. The 3
lenses will now face down the road away from the vehicle!
Laser Module
Bolt to License Plate
5/24/05 9:00 PM Page 17
Dog Bone
Bracket
15

Installation of Alarm LED

The intense blue LED provides additional visual alerts to laser-
radar signals. The molded-in LED holder provides easy panel
mounting. Simply drill a 5/16 hole into a removable panel and
insert the LED's wiring into the hole and press
gently the LED housing until a flush fit. (see drawing) The
LED could also be tie wrapped to the handle bars or
brake/clutch cables for an easy attachment.
Note: Do Not plug LED into the A A U U X X Output with the control
panel turned on. Damage to LED may occur.
Carefully route the cable to the control panel and plug into
the A A U U X X out connector.
16