Table of Contents
Advertisement
Cruisader Installation.qxd
Installation of Laser-Radar Antenna
General Information
The laser-radar antenna is water resistant and designed to be
mounted on a motorcycle, snowmobile, etc. Radar signals will
pass through non-metallic materials such as fiberglass and
plastic, however, be sure not to mount the receiver behind
any metal, as it will block the receiver's antenna. This receiver
also incorporates a laser detector. In order for the laser receiver
to "see", it can not be mounted behind any object. In some
installations, this is not possible. We supplied an additional laser
only receiver for this instance. If the installation allows for a clear
view for laser-radar receiver, the extra laser receiver can be used
for rear detection. Because the optimal location for mounting
the antenna varies by vehicle type, the hardware supplied is
designed to offer a wide variety of mounting options.
Note: The "antenna" is the bubble area on the case. All
references to antenna in this manual will be the bubble area.
Note:
Use of hardware that is not supplied or DRILLING
into the case will cause damage to the receiver and void the warranty.
Antenna Mounting Brackets
There are 3 ways in which to mount the laser-radar antenna;
dual lock fastener, reflector bracket and universal brackets
(similar to old car radio ground straps). These mounting
accessories can be used on their own or in combination to
provide the best mounting solution for the vehicle.
Do not drill into the receiver housing!
5/24/05
9:00 PM
Page 9
7
Installation of Laser-Radar Antenna
The reflector bracket serves two purposes; (1) to allow vertical
mounting of the antenna (see page 10 for vertical install
instructions) and (2); when mounted in reverse (angled portion
towards the wires.) allow the receiver to be installed on any
horizontal area.
(1)
Antenna
4x8 mm
SEMS
Dual Lock
Fastener
Reflector
(3) The heavy duty double lock fastener provides easy
installation with the option of easy removal without tools.
(4) The universal brackets are flexible but yet strong to hold
up to a motorcycle's vibrations.
(3)
Dual Lock
Fastener
Antenna
(2)
Dual Lock
Fastener
Reflector
Antenna
4x8 mm
SEMS
(4)
Reflector
Antenna
Universal
Brackets
4x8 mm Bolt
w/ Lock Washer
and Nut
4x8 mm
SEMS
8
Advertisement
Table of Contents
