Table of Contents
Advertisement
Cruisader Installation.qxd
Installation of Console
2. Auxiliary Port
1. Power Port
Laser-Radar Antenna Cable Connection
The stereo connector on the end of the Laser-Radar antenna
cable plugs into the ANT port (4) on the back of the control panel.
Laser Antenna Cable Connection
After mounting the laser antenna, conceal the cable and plug
the stereo jack connector into the port on the back of the
control panel labeled LAS port (3).
Power Cable Connection to the Battery
Caution: Always wear safety glasses and exercise caution when
working near the battery. Batteries emit hydrogen gas while
charging and may explode if sparks are present.
5/24/05
9:00 PM
Page 19
3. Laser Port
4. Antenna Port
17
Installation of Console
Power Cable Connection to the Battery (Cont.)
Locate the power and ground connection terminals on the
power cable. Connect the positive lead (wire with fuse holder)
to the positive terminal on the battery (on a conventional bat-
tery, remove the terminal first, on a side-mounted battery,
remove the wire assembly from the terminal). Connect the
other lead to the battery ground (the battery ground is gener-
ally a bolt located on the frame, adjacent to the battery).
Ground
Optional Connection Shown
on a Honda Goldwing
Note: For optimum performance and freedom from battery
related problems, make sure the battery terminals are clean
and free form any corrosion.
Using the supplied tie wraps, secure the excess power cable
away from all moving engine components.
Once the battery connections are finished, connect the cable
to the P P W W R R port (1) on the back of the control panel.
+12 Volt
18
Advertisement
Table of Contents
