Table of Contents
Advertisement
Replacing SFP Modules into SFP Module Slots
This section describes how to replace an SFP module.
Class 1 laser product. Statement 1008
Warning
To insert an SFP module into the SFP module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 1
Remove the antenna end cap by using a 3/8-in. wrench to loosen the bolts.
Step 2
Disconnect the LC from the SFP module.
Step 3
Tip
Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4
Caution
Step 5
Unlock and remove the SFP module.
Figure B-2
A
Pull the bale-clasp latch out and down to eject the module. If the bale-clasp latch is obstructed and you
Step 6
cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Step 7
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module
slot.
Place the removed SFP module in an antistatic bag or other protective environment.
Step 8
Caution
Cisco 3200 Series Router Hardware Reference
B-2
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Do not touch the optical surfaces.
Disconnecting SFP Latch Mechanisms
1
B
Do not remove the rubber plugs from the SFP module port or the rubber caps from the
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP
module ports and cables from contamination and ambient light.
2
Appendix B
SFP Module Replacement
3
4
OL-5816-10
Advertisement
Table of Contents
