Cisco 675E Hardware Installation Manual page 51

Chapter 2 Installation
Connecting the RPS 675
Figure 2-7 Connecting the AC Cable to the RPS 675
1 0 0 - 2 4 0
V ~
1 0 - 6 A 1 2 V / 2
5 A , - 4 8
V / 7 . 8 A
5 0 / 6 0 H
z M A X O
U T P U T
D C O U
T P U T 1
D C O U
T P U T 2
Step 7 Press the RPS Standby/Active button to put the RPS into active mode.
The Standby/Active, Output Power, Temperature, and Fan LEDs on the RPS front
panel should be green. The DC Output LEDs for the connected devices should
also be green. If they are not green, see Table 3-1 on page 3-1 for the appropriate
action to take.
Cisco RPS 675 Redundant Power System Hardware Installation Guide
2-17
78-15201-04