Installing The Switch; Table Or Shelf-Mounting - Cisco 675E Hardware Installation Manual

Installing the Switch

Installing the Switch

Table or Shelf-Mounting

Warning
Step 1
Step 2
Step 3
Note
Cisco RPS 675 Redundant Power System Hardware Installation Guide
2-8
One 16-pin-to-14-pin DC connector cable
•
Mounting kit that contains:
•
Four rubber feet for mounting the switch on a table
–
Two mounting brackets
–
Four Phillips flat-head screws for attaching the brackets to the switch
–
Four Phillips truss-head screws for attaching the brackets to the switch
–
Four Phillips machine screws for attaching the brackets to a rack
–
This section describes these installation procedures:
• Table or Shelf-Mounting, page 2-8
Rack-Mounting, page 2-9
•
Do not stack the chassis on any other equipment. If the chassis falls, it can
cause severe bodily injury and equipment damage. Statement 48
Follow these steps to install your chassis on a table or shelf:
Unpack the RPS 675.
Attach the rubber feet from the accessory kit into the round recesses that are
located on the bottom of the chassis.
Place the RPS 675 chassis on an appropriate table, shelf, or desktop.
If you have questions or need assistance, see the
Submitting a Service Request" section on page
Chapter 2
"Obtaining Documentation and
xxiv.
Installation
78-15201-04