Snmp Host Table - D-Link xStack DGS-3426 User Manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch

SNMP Host Table

Use the SNMP Host Table window to set up SNMP trap recipients. To delete an existing SNMP Host Table entry, click the
corresponding under the Delete heading. To display the current settings for an existing SNMP Group Table entry, click the
blue link for the entry under the Host IP Address heading. Click Administration > SNMP Manager > SNMP Host Table, which
will open the following window.
Users now have the choice of adding an IPv4 or an IPv6 host to the SNMP host table. To add a new IPv4 entry to the Switch's
SNMP Host Table, click the Add IPv4 Host button in the upper left-hand corner of the window. This will open the SNMP Host
Table Configuration window, as shown below.
The following parameters can set:
Parameter
Host IPv4 Address
SNMP Version
Community String or
SNMP V3 User Name
To add a new IPv6 entry to the Switch's SNMP Host Table, click the Add IPv6 Host button in the upper left-hand corner of the
window. This will open the SNMP Host Table Configuration window, as shown below.
Figure 6- 60. SNMP Host Table window
Figure 6- 61. SNMP IPv4 Host Table Configuration window
Description
Type the IPv4 address of the remote management station that will serve as the SNMP host
for the Switch.
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
90