Safety Instructions - Epson SC-S9150 Setup Manual

Safety Instructions

EN
Meaning of Symbols
The symbols on this Epson printer and this manual are used in order to ensure safety and proper use
of the product and to prevent danger to customers and other persons, and property damage. The
symbols indicate the meaning below.
The Symbols on the Printer
Be sure that you completely understand the meaning of symbols before using this printer.
Stand-by Alternating USB
Current
Caution, risk Disconnection
of electric (All power
shock plugs)
Symbols Used in This Manual
!
Warning
Warnings must be followed to avoid serious bodily injury.
!
Caution
Cautions must be followed to avoid bodily injury.
c
Important : Important must be followed to avoid damage to this product.
Note : Notes contain useful or additional information on the operation of this product.
Caution, keep Caution, Caution!
hands clear moving parts Shock hazard
Caution, hot Caution, risk Caution, keep
surface of danger hands clear
No fire
Important Safety Instructions
Read all of these instructions before using the printer. Also be sure to follow all warnings and
instructions marked on the printer.
Notes on Installing
Do not obstruct the vents on the product.
If the vents are obstructed, the internal temperature could rise and cause a fire. Do not cover the
printer with a cloth or install it in a location with poor ventilation. Make sure you secure sufficient
space for the installation as described in the manual.
Caution,
U See "Instructions for Placing the Printer" on page 12 of this guide.
moving parts
Do not setup or use this product in an area where children may come close.
Children may be injured by the equipment.
Use the product in a sufficiently ventilated area.
The smell and vapor of ink, waste ink, and ink cleaner may cause discomfort. If you feel unwell, take
the following actions:
❏ Move to an area with fresh air.
❏ Wear a protective mask.
❏ If breathing is difficult or has stopped, perform artificial respiration immediately and seek medical
attention.
Do not install or store the printer in an unstable location or a location subject to vibrations from
other equipment.
The printer could fall or tip over and cause an injury.
Do not install the printer in locations subject to oily smoke and dust, or in locations subject to
humidity or where it could easily get wet.
An electric shock or fire could occur.
Do not tilt the product more than 10 degrees forward, back, left, or right while moving it.
Failure to observe this precaution could result in the printer falling over, causing accidents.
Because the product is heavy, it should not be carried by one person.
At least eight persons are needed to unpack or carry the printer. See the following for details on
the product's weight.
U See "Instructions for Placing the Printer" on page 12 of this guide.
When lifting the product, make sure you lift at the locations indicated in the manual.
If you lift holding other parts, the printer may fall, catching your fingers and causing an injury. See
the following for details on lifting the product.
U See "Printer Installation" on page 20 of this guide.
!
Warning
!
Caution
5