Table of Contents
Related Manuals for EF EFH 3971 TN VSB
Summary of Contents for EF EFH 3971 TN VSB
- Page 1 Model: BUILT-IN GAS HOB EFH 2760 TN VSB BATTERY IGNITION EFH 3762 TN VSB EFH 3763 TN VSB EFH 3970 TN VSB EFH 3971 TN VSB EMBRACING FINEST MOMENTS USER MANUAL EFH 3763 TN VSB EFH 3762 TN VSB EFH 2760 TN VSB...
-
Page 2: Safety Guidelines
Dear Customer, Thank you for having purchased and given your preference to our product. This manual provides a means to make full use of the features of this product. The safety precautions and recommendations are also featured in this manual. We recommend that you read this manual for best performance and to extend the life of your appliance. Please preserve this manual for future use, in the event that doubts arise relating to the operation. - Page 3 ➢ Using unstable or deformed cookware ➢ Trying to install or repair the appliance without the assistance of qualified personnel. PRODUCT FEATURES AND TECHNICAL DATA EFH 2760 TN VSB EFH 3762 TN VSB EFH 3763 TN VSB EFH 3970 TN VSB EFH 3971 TN VSB 1.
-
Page 4: Technical Specifications
TECHNICAL SPECIFICATIONS Product Image EFH 2760 TN VSB EFH 3762 TN EFH 3970 TN EFH 3971 TN Model Number EFH 3763 TN VSB Product WxDxH 780 x 450 x 60 860 x 500 x 60 Dimension (mm) Cut-out 660~750 x 360~420... -
Page 5: Operation Of The Appliance
OPERATION OF THE APPLIANCE FIRST USE Remove any protective foil if there is any. Ensure that the burner cap is properly positioned. Clean the stainless steel top plate with damp clothes and then wipe dry NOTE: There is a protective coating for the metal components. When heat up for the first time, it is normal that the metal components will give some smell. -
Page 6: Igniting The Burners
IGNITING THE BURNERS The appliances come with auto ignition and flame safety device. Proceed as follows to ignite the burner： 1) Press and turn the corresponding knob in anti-clockwise direction to the “High” setting “ ”. 2) Hold the knob for 3 to 5 seconds to light the gas and to permit the flame failure device to heat up. 3) Release the knob after 3 to 5 seconds and adjust the flame to the desired power position. -
Page 7: Cleaning And Maintenance
➢ Any heat resistance pots or pans can be used on gas cooker. ➢ When using wok adaptor, the recommended wok size is Ø36cm AUTOMATIC SAFETY VALVES This safety device automatically closes the gas valve if the flame accidentally extinguished. CLEANING AND MAINTENANCE Cleaning and maintenance should be carried out after the appliance has turned cold especially when cleaning burners and enameled or cast iron parts. - Page 8 CORRECT PLACEMENT OF THE SEMI-RAPID AND RAPID BURNERS It is very important to check that the burner flame distributor “F” and the cap “C” have been correctly positioned (see Fig.1, Fig.5) - failure to do so can cause serious problems. CORRECT PLACEMENT OF THE TRIPLE RING BURNER The triple ring burner must be correctly positioned (Fig.2);...
-
Page 9: General Advice
Note: • The burner caps will become more matt over a period of use. This is normal due to high flame temperature and it does not affect the functional of the burner. • Both the probe and ignition plug should be very carefully cleaned with a dry cloth. GAS TAPS Periodic lubrication of the gas taps must be carried out by specialist personnel only. -
Page 10: Installation
ADVICE FOR THE INSTALLER IMPORTANT: ⚫ The appliance should be installed, regulated and adapted to function with other types of gas by a QUALIFIED INSTALLATION TECHNICIAN. Failure to comply with this condition will render the guarantee invalid. ⚫ The appliance must be installed in compliance with regulations in force in your country and in observation of the manufacturer’s instructions. -
Page 11: Cutout Dimensions
CUT-OUT DIMENSIONS Please be ensure to use the correct dimensions as shown below for installation. Model Cut-out Dimension (W x D mm) EFH 2760 TN VSB EFH 3762 TN VSB 660~750 x 360~420 EFH 3763 TN VSB EFH 3970 TN VSB... -
Page 12: Ventilation Requirement
INSTALLATION IN KITCHEN CABINET WITH DOOR The fixture has to be made according to specific requirements in order to prevent the gas burners from going out, even when the flame is turned down to minimum, due to pressure changes while opening or closing the cupboard doors. -
Page 13: Gas Section
SETTING UP THE HOB FOR INSTALLATION Every cooker top is provided with a set of tabs for fitting to the fixture panel with thickness from 3 to 4 cm and a seal with adhesive on one side, and one battery (D size). ➢... -
Page 14: Gas Connection
GAS CONNECTION The appliance should be connected to the gas-supply by licensed installer. During installation of this product, it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. -
Page 15: Testing Operation
IMPORTANCES: • Prior to installation, ensure that the local distribution conditions (nature of gas and gas pressure) and the adjustment of the appliance is compatible • Never attempts to turn the elbow without having first slackened off the relative lock nipple. •... -
Page 16: Lubrication Of The Gas Taps
√ Remove the pan supports and the burners; √ Using a wrench, substitute the nozzle injectors; “J” (Fig.14) with those most suitable for the kind of gas for which it is to be used. The burners are conceived in such a way so as not to require the regulation of the primary air. - Page 17 TYPE OF IGNITION The models come with battery operated ignition. BATTERY IGNITION nsert a DC1.5V battery (Size “D”) into the battery compartment located at the bottom of the appliance (Fig.17). Check for correct polarity when insert the battery Important notes: •...
-
Page 18: Self Check
SELF CHECK In the event of any abnormal occurs during operation of the gas hob or the gas hob does not function properly, you may do a self-check before contacting customer service officer. Disconnect the hob from gas connection before checking. -
Page 19: Warranty And Service
WARRANTY & SERVICE • To activate your warranty, please register your appliance. • Warranty registration can be done via our website or scan the QR code below Website https://shop.casa.sg/E-Warranty QR Code Scan the QR Code below. It will redirect straight to our “Warranty Registration” page. Casa (S) Pte Ltd.
Need help?
Do you have a question about the EFH 3971 TN VSB and is the answer not in the manual?
Questions and answers