Rear View - VINCENT SV-238MK Instructions For Use Manual

6. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pair(s) of loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used. Please take note of the information given
in the section "Installation", if two pairs of loud-
speakers will be connected to the amplifier.
7. POWER CONTROL (12V) OUTPUT
These jack connectors (3,5 mm) send the signals
for the standby control (12V Trigger).
8. INPUT ("LINE1"..."LINE5"):
Terminal for stereo audio signals
of the RCA source equipment
Here you find five stereo RCA input sockets for
source equipment with analogue stereo (line level)
audio output.
Vincent
28

REAR VIEW

6 8
7
10
9
9. PRE OUTPUT: Preamplifier Outputs
This output can supply up to four additional main
amplifier channels or an active subwoofer with the
preamplified audio signal of the selected source.
10. INPUT "BALANCED": XLR-Input
These are the input sockets for one stereo audio
source equipped with XLR output sockets.
11. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a 230V
AC wall outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the secu-
rity precautions.
6
11