TYAN TRINITY KT-A Manual page 47

RxD, TxD Active
This setting is reserved and should be left as default. Default setting is Hi, Lo
IR Transmission delay
Adjust this setting to set the delay before a signal is sent through the IR port.
Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical parallel
port.
Onboard Parallel Mode
This option allows the user to select a mode for the onboard parallel port.
ECP Mode Use DMA
Allows the parallel ports to enable DMA, this a faster transfer rate.
EPP Mode Select
This setting selects the printer port's data transfer mode.
PWRON After PWR-Fail
This function enables the computer to power up or down after a sudden power
interruption. If the setting is set to OFF, the computer will stay off even if the power
is resumed. If it is set to On, the computer will power on when power is restored. If
the setting is set to Former-Sts, the computer will return to the previous state before
the power was interrupted.
S2390B Trinity KT-A
47