Cmos Reset - TYAN TRINITY I845 User Manual

2.2 CMOS Reset (JP1)
If you have been locked out of your system because you forgot your password, or set the CMOS
incorrectly, or have just finished flashing your BIOS, you will need to reset the CMOS. The
instructions are as follows:
1. Power off the system
2. Close pins 2-3 on JP1
3. Wait about three seconds
4. Close pins 1-2 on JP1, then power on the system again
By following this procedure, you will erase your password and reset the CMOS. The location of
JP1 is shown in the diagram below.
10
http://www.tyan.com
JP1
CLOSE 1-2
Normal
* default is CLOSE 1-2
CLOSE 2-3
Clear CMOS