Table of Contents
Advertisement
2.6-J. Soft Power Connector
The soft power connector is part of jumper block J1 (pins 6 to 8). This board uses the chipset for power
management, including turning on and off the system. If the power button function option in the BIOS
Power Management menu is set to "On/Off" (which is the default), pressing the power button once after
the BIOS has booted up will turn the system on and off. If the power button function is set to Suspend,
pressing the power button once will wake up the system or send it to Suspend mode. In this case, you
cannot turn the system off unless you shut down through the Windows operating system or you hold the
power button down for four seconds.
2.6-K. Hardware Reset Switch Connector Installation
The reset switch on your chassis case provides you with the Hardware Reset function, which is the same
as power on/off, except that the system will immediately execute a cold start after the reset button is
pushed.
2.6-L. Flash Utility
You can upgrade the BIOS of this motherboard by using the Flash Utility (see p. 37). Check the Tyan
website for details: http://www.tyan.com
* check the Tyan website for updates: http://www.tyan.com
14
http://www.tyan.com
Advertisement
Table of Contents
