Power Management Setup - TYAN TRINITY 450 Manual

(continued from previous page)
Onboard Parallel Port
Onboard Parallel Mode
ECP Mode Use DMA
Parallel Port EPP Type

3.6 Power Management Setup

This section describes the different power management functions that may be available on your system.
Please note that power management functions are also dependent on your OS' power management func-
tions, and that both OS and system power management functions should be set up to work in conjunction
with one another.
ACPI Function
Power Management (subscreen)
Power Management
HDD Power Down
Doze Mode
Suspend Mode
ACPI Suspend Type
PM Control by APM
Video Off Option
Video Off Method
Modem Use IRQ
(continued on next page)
34
Sets logical LPT port address and corresponding interrupt.
[Default setting is 378/IRQ7]
Sets mode for onboard parallel port. [Default setting is Normal]
Sets whether parallel port should use DMA for faster transfer
rate. [Default is 3]
Sets parallel port data transfer mode. [Default is EPP1.9]
Enable or Disable Advanced Configuration Power Interface.
[Default setting is Enabled]
Lets you enter the screen for configuring power states.
Sets whether each mode should be set separately. [Default is
User Define]
Sets time that system should wait before powering down the
HDD(s). [Default is Disable]
Sets time that system should wait before CPU clock runs at
slower speed to save power. [Default is Disabled]
Sets time that system should wait before suspending all devices
except for CPU, to save power. [Default is Disabled]
Sets type of suspend function to enable once the system enters
suspend mode. [Default is S1(POS)]
Reserved. [Default is Yes]
Sets power-saving mode for video display. [Default is Suspend-
>Off]
Determines manner in which the monitor is blanked. [Default is
V/H SYNC+Blank]
If Modem Ring Resume is Enabled, it's possible to wake the
system up by dialing into it. [Default is 3]
http://www.tyan.com