Tools Required For Assembly; Assemble Wheels - Delta Oil-Free 66-651 Instruction Manual

Tools Required for Assembly

1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove all packaging leaving the air compressor on the pallet.
2. Remove and discard the (4) screws
holding the air compressor to the
pallet.
side of the air compressor when
removing the pallet because the air
compressor will have a tendency to tip.
3. Carefully remove the air compressor from the pallet.

Assemble Wheels

It will be necessary to brace or support one side of the
outfit when installing the wheels because the compressor
will have a tendency to tip.
1. Attach wheels with shoulder bolts and nuts as shown.
2. Tighten securely. NOTE: The outfit will sit level if the wheels are properly
installed.
down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the screws provided as shown in previous figure.
2. Tighten securely.
ASSEMBLY
It may be necessary to
brace or support one
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up and
Nut
Wheel
9- ENG
Screws
Rubber Feet
Screw
Shoulder Bolt
D26195