System Q; Audio Control - Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual

General features
System Q
Audio Control
Selecting the best sound setting preset for
different types of music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
When you press the button once, the current
sound setting is displayed.
Each time you press the button, the sound
setting alternates.
• *
User memory: The values set on the <Audio
Control> (page 12).
KDC-MP532U does not have the User memory
function so the values of Bass, Middle, and Treble set
in audio control are replaced to the System
Q
values
and "USER" is not displayed when the System
Q
setting is changed.
• Change each setting value with the <Speaker
Setting> (page 14).
First, select the speaker type with the Speaker setting.
User memory*
Rock
Pops
Easy
Top 40
Jazz
Natural
~
~
"USER"
"ROCK
' 1
"EASY"
"TOP 40"
"JAZZ"
"NATURAL "
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
RearVolume
*1,2
"R-VOL" 0- 35
Subwoofer level*1,3,4,S "SW L" -15 -
+
15
Bass level*6 "BAS L" -8 - +8
Middle level*6 "MID L" -8 - +8
Treble level*6 "TRE L" -8 - +8
Balance "BAL" Left 15 - Right 15
Fader*s "FAD" Rear 15 - Front 15
Exit Audio Contra! mode (Vo!ume contro! mode)
~
~
• *1
Function of KDC-X590/MP632U.
• *2
You can control this item when "2Z0N" of <Audio
Setup> (page 14) is set to "ON".
• *3
You can control this item when <Switching preout>
(page 30) is set to "SWPRE SW". (KDC-MP632U only)
• *4
You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
• *5
You can control this item when "2Z0N" of <Audio
Setup> (page 14) is set to "OFF".
• *6
You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page13).
(KDC-X590 only)
• *6
Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included:
KDC-X590 only)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[AD] button.
12
I
English