Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual page 41

Connecting Wires to Terminals (KDC-MP532Uj
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
~
• Do not remove the cap when you do not use the
~
USB cable. The connector will cause the unit to
malfunction if it gets in touch with any metallic part
of the vehicle.
• Fasten the connector with the tape so that the cable
will not come off.
Front right output (Red)
Front left output (White)
ANT.
CONT
[0
To USB device
Rear left output (White)
Rear right output (Red)
USB connector
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
~
To connect the Kenwood navigation
~
system, consult your navigation manual.
To car light control switch
8
White/Black
To front left speaker
White
®
8
Gray/Black
To front right speaker
Gray
®
8
Green/Black
To rear left speaker
Green
®
8
Purple/Black
To rear right speaker
Purple
®
Ignition key switch
([)=
@
Car fuse box
Car fuse box
(Main fuse)
ACC
Ignition wire (Red)
. . . - - - - - - - - - - - - - - - - -..... 11
Battery wire (Yellow)
Ground wire (Black)
8
(To car chassis)
English
I
41