Advanced Setup - TYAN TITAN III Manual

w w Primary Master
w w Primary Slave
Select one of these hard disk drive Icons to configure the drive named in the
option. WINBIOS supports up to four IDE hard disk drives: the primary
master, primary slave, secondary master and secondary slave. If the hard
disk drive is an IDE drive, select DETECT PRIMARY or DETECT SLAVE
from the Utility Setup Option Section of the WINBIOS Setup Main Menu
to have WINBIOS automatically detect the IDE drive parameters and re-
port them to this screen.The SCSI option must be selected if a SCSI Disk
Drive installed.
You can also manually enter the hard disk drive parameters. Hard disk type
47 is the user-definable drive type. The drive parameters are: Type, Cylin-
ders, Heads, Write precompensation, Landing Zone, Sectors and Capacity.
w w Floppy Drive A:
w w Floppy Drive B:
Move the cursor to these fields via the up and down arrow keys and select
the floppy type. The settings are 360 KB 5 1/4 inch, 1.2MB 5 1/4 inch,
720MB 3 1/2 inch, 1.44MB 3 1/2 inch and 2.88MB 3 1/2 inch..

5.2 Advanced Setup

The WINBIOS Setup options described in this section are selected by
choosing the Advanced Setup Icon from the WINBIOS Setup Main
Menu.
w w Typematic Rate (Chars/Sec)
Set the rate at which characters on the screen repeat when a key is
pressed and held down. The Optimal setting is 30 characters per
second. The Fail-Safe default setting is disabled.
w w System Keyboard
Specify if error messages are displayed when a keyboard is not
attachted. This option permits you to configure workstations with no
keyboards. The Optimal and Fail-Safe default settings are Present.
S1468-001-01 45