TYAN TIGER I7520SD Manual page 66

70H TP_ERROR_MSGS
72H TP_TEST_CONFIG
74H TP_RTC_TEST
76H TP_KEYBOARD
7AH TP_KEYLOCK
7CH TP_HW_INTS
7DH TP_ISM_INIT
7EH TP_COPROC
80H TP_IO_BEFORE
81H TP_LATE_DEVICE_INIT
82H TP_RS232
83H TP_FDISK_CFG_IDE
84H TP_LPT
85H TP_PCI_PCC
86H TP_IO_AFTER
87H TP_MCD_INIT
88H TP_BIOS_INIT
89H TP_ENABLE_NMI
8AH TP_INIT_EXT_BDA
8BH TP_MOUSE
8CH TP_FLOPPY
8EH TP_AUTOTYPE
8FH TP_FDISK_FAST_PREINIT
90H TP_FDISK
91H TP_FDISK_FAST_INIT
92H TP_USERPATCH2
93H TP_MP_INIT
95H TP_CD
Displays any errors found.
Checks for bad configurations.
(Optional)
Reports if there was a keyboard or
controller failure.
(Optional)
Initializes hardware interrupt
vectors.
(Optional)
Tests for coprocessor.
(Optional)
POST device initialization routine.
(Optional)
(Optional)
Configures Non-MCD IDE
controllers.
(Optional)
Configures PnP PCC devices.
(Optional)
(Optional)
Configures MCD devices.
Initializes timeouts, key buffer, soft
reset flag.
Enable NMIs.
Initializes extended BIOS data
area.
Checks if mouse is installed,
displays "Installed" message.
(Optional)
POST task for installing and
initializing legacy floppy disk
drives.
(Optional)
(Optional)
Tests hard disks.
Programs timing registers
according to PIO modes.
(Optional)
Jump to UserPatch2.
Creates the MP table. (Optional)
Installs CD-ROM for boot.
(Optional)
66