TYAN THUNDER X Manual page 29

NOTE: The orientation of the handle to the CPU depends on which slot the CPU
! ! ! ! !
will be inserted to. (See page 2-4 for location of the slots.)
important!
Installing CPU 1
First attach the handle to the top of CPU1. Align the handle so that the screw
holes of the handle are on the OPPOSITE side of the cooling fan or heat sink.
See Figure 2-13.
Screw Hole
(opposite side of fan)
Figure 2-13
When the handle is securely installed, you are ready to plug in the CPU. Slide the
CPU between the two retention braces and onto CPU1 slot. Make sure that the
fan or heat sink is facing away from the edge of the motherboard. Press down
firmly on the handle until the CPU is securely in the slot (see Figure 2-14 below).
Be sure to screw the handles onto the retention braces after CPU is inserted.
Figure 2-14
S1952DLU Thunder X
2-19