TYAN THUNDER N4250QE Manual page 54

3.3.7 I/O Device Configuration
This setting allows you to configure I/O devices.
Main Advanced
I/O Device Configuration
Serial port A:
Base I/O address:
Interrupt:
Serial port B:
Mode:
Base I/O address
Interrupt:
Parallel port:
Mode:
Floppy Disk Controller:
Base I/O address:
F1 Help ¡ ô ¡ õ
Esc Exit ¡ ö ¡ ÷
Serial Port A
This defines how the serial port is detected and configured.
Enabled / Disabled / Auto
Base I/O Address
This sets the base I/O address for serial port A.
3F8 / 2F8 / 3E8 / 2E8
Interrupt
This sets the interrupt for serial port A.
IRQ4 / IRQ3
Serial Port B
This defines how the serial port is detected and configured.
Enabled / Disabled / Auto
Mode
This feature is used to set the mode for serial port B.
Normal / IR / ASK-IR
PhoenixBIOS Setup Utility
Memory
[Enabled]
[3F8]
[IRQ4]
[Enabled]
[Normal]
[2F8]
[IRQ3]
[Auto]
[ECP]
[Enabled]
[Primary]
Select Item -/+
Select Menu Enter
Security Boot
Change Values
Select
Sub-Menu
54
Power
Item Specific Help
F9 Setup Defaults
F10 Previous Values
Exit