Fröling TI Service Handbook

page of 116

/ 116
Contents
Table of Contents
Bookmarks

Table of Contents

Table of Contents
General
About These Instructions
Safety Information
Power Connection and Wiring
Core Module and Connection Options
Board View - Core Module
Mains Connection
Connecting the Outside Temperature Sensor
FRA Room Temperature Sensor
Boiler Enable Contact
Connecting a Circulating Pump to the Core Module
Connecting a Circulating Pump with Valve to the Core Module
Heating Circuit Pump 0 / Burner Relay
Operating Signal
Expansion Modules
Heating Circuit Module
Hydraulic Module
Wood Chip Module
Plug Power Pack FRSNT17
Plug Power Pack Meanwell LRS-100-24
Analogue Module
Digital Module
BUS Connection
Connecting the Bus Cable
Setting End Jumpers
Setting the Module Address
Potential Equalisation / Potential Separation
Connection Information According to Pump Types
Frequency Converter
Operating Elements
Changing Parameters
Initial Start-Up with Settings Wizards
Before Switching on for the First Time
Controller Check
Check on the Connected Units
System Check
General Information about the Settings Wizard
Switching on for the First Time
Starting the Setting Wizard
Parameters Overview
Heating
Heating - Status
Heating - Temperatures
Heating - Times
Heating - Service
Heating - Heating up Program
Heating - General Settings
Water
Water - Status
Water - Temperatures
Water - Times
Water - Service
Solar
Solar - Status
Solar - Temperatures
Solar - Times
Solar - Service
Solar - Heat Meter
Buffer Tank
Buffer Tank - Status
Buffer Tank - Temperatures
Buffer Tank - Times
Buffer Tank - Service
Boiler
Boiler - Status
Boiler - Temperatures
Boiler - Times
Boiler - Service
Boiler - General Settings
Boiler 2
Boiler 2 - Status
Boiler 2 - Temperatures
Boiler 2 - Service
Fuel
Fuel - Parameter
Feed System
Feed System - Screw 1 on LB
Feed System - Cyclone 1
Network Pump
Network Pump - Status
Network Pump - Temperatures
Network Pump - Service
Cascade
Cascade - Status
Cascade - Temperatures
Cascade - Service
Difference Regulator
Difference Regulator - Status
Difference Regulator - Temperatures
Difference Regulator - Times
Difference Regulator - Service
Circulation Pump
Circulation Pump - Status
Circulation Pump - Temperatures
Circulation Pump - Times
Circulation Pump - Service
Manual
Manual - Manual Operation
Manual - Digital Outputs
Manual - Analogue Outputs
Manual - Digital Inputs
System
System - Setting
System - Current Values
System - Sensors and Pumps
System - System Selection
Diagnostics
Diagnosis - Current Fault List
Diagnosis - Clear Pending Error
Diagnostics - Error History
Diagnostics - Clear Error History
Touchscreen
Touchscreen - Display Settings
Touchscreen - Display Operating Rights
Touchscreen - Display Allocation
Faq
Activation Options of Pump Outlets
Pump Stall Protection
Boiler Operating Statuses
Determination of the Quantity of Heat
Assembly Information
Functioning and Configuration
Boiler Modes
Automatic" Mode Without Storage Tank
Automatic" Mode with Storage Tank
Continuous Load" Mode Without Storage Tank
Continuous Load" Mode with Storage Tank
Domestic Hot Water" Mode Without Storage Tank
Domestic Hot Water" Mode with Storage Tank
Setting Times
Calibrating the Touchscreen
Software Update Lambdatronic 3200
Carrying out a Software Update on the Boiler Controller
Carrying out a Software Update on the Touch Control
Finishing a Software Update
USB Data Recording

Quick Links

Download this manual

Service handbook

Lambdatronic H 3200 - TI

Core module version 55.04 - Build 05.21 | Touch control version 60.01 Build 01.39

Translation of original German version of service handbook for technicians.

Read and follow all instructions and safety instructions.

All errors and omissions excepted.

B1850023_en | Edition 21/03/2024

Table of Contents

Need help?

Do you have a question about the TI and is the answer not in the manual?

Fröling TI Service Handbook

Quick Links

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Fröling TI

Table of Contents