Installation And Removal Of Passive Processors - TYAN TAHOE PLUS ATX Manual

3.4 Installation and Removal of Pentium II Passive Processors
(Unlike Active Processors, Passive Processors are not equipped with
Pentium II Passive CPU Module
3.4.1 Installing CPU
Retention Modules
1. When installing the CPU
Retention Module, make sure
that you have the appropriate end
of the module lined up with the
key notch on the Pentium II Slot
connector. This will ensure
that the module is installed
properly.
2. Before tightening the screws, make certain that the module is flush
against the motherboard. If one end of the module is raised above the
board, check the orientation of the module.
3. Install the module on the board by turning the screws in a clockwise
direction. (Do not over tighten the screws).
S1686S/D-001-02 http://www.tyan.com
cooling fans. Passive
Processors are equipped
with heat sinks instead.)
Each CPU package should
also contain the following:
CPU Retention Module (x1)
Heat-sink Retention Bracket
with mounting locks (x1)
Mounting Attach-mounts (x
2) Heat-sink Lock (x1)
Retention Module
20