TYAN TAHOE 2 ATX Manual page 23

3.4.4 Installing Heat-sink Locks
The heat-sink lock has 4 notches which will correspond to the 4 pins on
the heat-sink mounting bracket. Gently slide the lock between the heat-
sink onto the heat-sink mounting bracket until both sides of the lock are
firmly secured. A clicking sound will be heard when the lock is securely
fastened to the heat-sink mounting bracket. To remove the lock from the
heat-sink mounting bracket, gently
press the ends of the locks inward
and pull.
3.4.5 Removing Pentium II Passive Processors and CPU
Retention Modules
To remove the CPU, move the locks to the center of the CPU. A click
will be heard when the CPU has been unlocked. Gently pull up on
the CPU, taking care not to bend the motherboard or the CPU Reten-
tion Module.
3.4.6: Removing Heat-Sink Locks
To remove the lock from the Retention Bracket, gently press the ends
of the locks inward and pull.
S1682D-001-02
Heat-Sink Lock
23