Volvo C30 Owner's Manual page 50

Trip computer (option)
Controls
To scroll through trip computer information
turn the thumbwheel (B) either up or down in
steps. Continue turning to return to the start-
ing point.
NOTE
If a warning message interrupts while you
are using the trip computer, this message
must be acknowledged. Acknowledge by
pressing the READ button (A) and revert to
the trip computer function.
Functions
The trip computer displays the following
information:
•
AVERAGE SPEED
• ACTUAL SPEED MPH
• INSTANTANEOUS
• AVERAGE
• KILOMETRES TO EMPTY TANK
• , see page 126
STC/DSTC
AVERAGE SPEED
When the ignition is switched off, the average
speed is stored and used as the basis of the
new value when you continue driving. Reset
using the RESET button (C).
1
ACTUAL SPEED MPH
Current speed is displayed in mph.
INSTANTANEOUS
Current fuel consumption is calculated every
second. The information on the display is
updated every couple of seconds. When the
car is stationary, " ---- " appears on the dis-
play. During the period for regeneration
consumption may increase, see page 115.
1
Certain countries
2
Only applies to diesel cars with particle filter.
02 Instruments and controls
Left-hand stalk switch
AVERAGE
The average fuel consumption is stored
when the ignition is switched off and remains
until the function is reset. Reset using the
RESET button (C).
NOTE
There may be a slight error in the reading if
a fuel-driven heater is used.
KILOMETRES TO EMPTY TANK
The range to empty is calculated based on
the average fuel consumption over the last
30 km. When the range to empty is shorter
than 20 km then "----" is shown on the dis-
play.
NOTE
There may be a slight error in the reading if
fuel consumption is changed due to a
change in driving style or if a fuel-driven
heater is used for example.
Resetting
2
– Select
AVERAGE SPEED
fuel
– Press and hold the RESET button (C) for
at least five seconds to reset the average
speed and average consumption at the
same time.
02
or
AVERAGE
49